Using smart phone flash tool in uart mode
The SP Flash Tool is having problems with reading the MTK smartphone or tablet device. UART Clip features a wide range of resistor.
The sender is a PC using a USB to serial converter, I doubt that it is sending at non-standard rates, although I think my next step is to look at the incoming signal on a scope and try to figure this out, unless one of the experts here can tell me why this might be happening. Fix: Load the correct scatter file and try flashing again. UART Clip for NS Pro Box is a multifunctional solution for flashing and decoding LG and Samsung cell phones.
USING SMART PHONE FLASH TOOL IN UART MODE GENERATOR
I tried slowing the baud rate, moving the generator to SMCLK and sourcing it from a faster DCO (still based on the REFO, this board has no crystal), and no luck - always the same issue. Flash Tool (Runtime Trace Mode) v5.6 download from. Smart Phone Flash Tool (Runtime Trace Mode) for Windows Download Free. At all rates (1200, 2400, 48), the Tx comes out fine, the Rx comes, 99.9% of the time with a framing error (UCA1STAT shows 0x24, meaning UCRXERR and UCOE), and when that fails to happen, and the UCA1STAT register does not register an error, (0.1% of the time), the incoming character is wrong I have been sending 0x31, and it will be received as 0x32 in the few times I have managed to catch it. Smart Phone Flash Tool (Runtime Trace Mode) is that solution. I am using REFO as ACLK, and as the baud-rate generator, but even when slowing down to 1200bps, it is not working. It works in Tx, but in Rx I am always getting framing errors. I've just taken a new board with an MSP430F5510 on it, and starting from sample code, started writing a driver for the UART. Other Parts Discussed in Thread: MSP430F5510